Here we offer suitable LED bulbs, lamps and lights for campers, caravans, caravans, but also for boats and yachts.
Or simply: Everything about lighting which is powered by Accus!
Our tip: When comparing the price of LEDs from different suppliers, always pay attention to the technical details (eg lumen, CRI, Kelvin, consumption, etc.).
Because: Same or similar looking products can differ significantly!
Avoid the use of non-voltage-stabilized 12V LEDs, as a fully charged 12V battery (battery) about 14.4V and a 24V battery have about 28V voltage! Due to the permanent overvoltage of the LED, the risk of premature destruction of the LED bulb or further damage to the vehicle can be considerably increased!
Visit us on Facebook to find out more about us!
We offer here a large selection of various lights, all of which, depending on the used bulbs, in 12V / 24V can be used! (Recessed lights, surface spots or under-floor lights, ceiling lights, rail spots, etc.). The light sources can be individually equipped with the appropriate for you LED bulbs!
Note: Bulbs are not included in most lights!
Please note the information in the detail view of the individual luminaires!
Type of G4 LED bulbs: pin Ø approx. 0.79 mm, pin spacing 4.0 mm.
G4 H LED modules (with the additional designation "H") are used i.a. used in recessed luminaires with laterally seated G4 socket.
G4 V LED bulbs with central connection (vertical), i.a. used in surface-mounted luminaires with a centrally located socket.
Type of construction of GU4 / GZ4 MR11 LED: Ø Illuminant approx. 35 mm, height without pins 28-30 mm, Ø pins approx. 1.00 mm, pin distance 4.0 mm.
We carry Top GU4 / GZ4 MR11 bulbs for your recessed luminaire or surface-mounted luminaire, such as the 30 ° Power Epistar as glare-free reading spot.
Type of GU4 MR8 LED: Ø Illuminant 25 mm, height without pins 25 mm, Ø pins approx. 1.00 mm, pin spacing 4.0 mm.
Use our GU4 MR8 LED light bulb for our 6-flame "Patricia" ceiling light, which was installed in Hobby motorhome and caravan.
Type of MR16 LED: Ø Illuminant 50 mm, height 40 mm, Ø pins approx. 1.5 mm, pin distance 5.3 mm
These LED illuminants are primarily used in a recessed or surface mounted luminaire. Only the complete halogen unit or glass, reflector and halogen pin base are removed and replaced by the MR16 LED.
Also replaces bulbs called W16W and W3W
Type of E14: 14 mm Ø thread, similar to 230V candle bulb.
All luminaires with an E14 socket in the low voltage range (12 volts) can be operated with these LED lamps
Not in full use 230!!
Type of E27: 27 mm Ø thread, comparable to 230V bulb (eg 60mm Ø)
All luminaires with an E27 socket in the low voltage range (12 Volt) can be operated with this LED illuminant!
Not in full use 230!!
These illuminants are primarily used in outdoor lighting, wardrobes, refrigerators, storage compartments and in the cab or as indirect lighting.
Only the glass utensils are taken out and replaced by the LED soffits.
The regular length of the soffit is measured over the tips.
Our LED light strips can u. a. used in exchange for fluorescent tubes or as a stand-alone luminaire or surface-mounted, outdoor and u. s. w. be used.
Since in our vehicles by the state of charge of the batteries (rechargeable batteries) constantly changing voltage state is present (usually the voltage oscillates between 11 and 14.4 volts) and there are normally only light strips with 12V or 24V, it has been very difficult to appropriate To find light strips. Only through the use of high quality LEDs with a voltage range of 12-14V (the measurement was carried out at maximum operating voltage), the voltage range of 11-14.4V could be secured.
Bayonet Ø 9mm with a central pole and 2 lateral retaining pins at the same height
Bayonet Ø15mm with a center pole and 2 lateral retaining pins at the same height
This pedestal is available in many "older" motorhomes, caravans and navy. Very often we see this version but also in the storage spaces or "garages" of new campers (eg., Liner) using a 21 watt bulb (for us UNBREIFLICH !!!).
Bayonet Ø15mm with 2 central poles and 2 lateral retaining pins at the same height.
This pedestal is available in many "older" motorhomes, caravans and navy.
Bayonet Ø15mm with 2 central poles and 2 lateral retaining pins at different heights.
This base is widely used in the Navy (boats, yachts and ships), but also in motorhomes and caravans.
Note: With these bulbs, one Pohl at the lower end is plus and the other minus, minus is not on the sleeve. These bulbs are not suitable for replacing a 2-phase bulb (for example 21 / 5W)!
Bayonet Ø20mm with 2 central poles and 2 lateral holding pins at the same height, about 13mm from below.
These LED bulbs are also used in scooters, motorcycles and ATV quads in the headlight (even these vehicles have up to 15V voltage!).
Our accessories include dimmers, adapters, sockets, connection cables, flashlights and much more. what makes the LED lover's heart beat faster.
Here we offer halogen bulbs as loose not individually packaged goods.